ATEM Setup + Auto-Detect Model
Quick Start
Go to Equipment settings and enter your ATEM's IP address
Click Connect and wait a few seconds
Confirm the model name appears (e.g., "ATEM Mini Pro ISO")
Test switching between camera inputs
Who This Is For
Teams using Blackmagic ATEM switchers for video switching.
What You Will Accomplish
Connect Tally to your ATEM switcher
Verify the model is detected automatically
Test basic switching, streaming, and recording controls
Prerequisites
Step-by-Step Setup
Open Equipment settings and enter your ATEM's IP address.
Click Connect and wait for the status to update. This usually takes 2-5 seconds.
Check that the correct model name appears in the ATEM status panel (e.g., "ATEM Mini Pro ISO").
Try these basic controls:
Change the preview input
Change the program input
Do a Cut transition
Do an Auto transition
Check that streaming/recording status updates correctly
If you're using the ATEM for audio, confirm that audio sources show up correctly.
Note: Audio detection works slightly differently depending on your ATEM model. Newer models use the Blackmagic Fairlight audio system, while older models use the classic audio mixer.
Validation Checklist
Common Issues and Fixes
| Symptom | Cause | Fix |
|---|---|---|
| ATEM not reachable | Wrong IP or different network | Double-check the IP address; make sure both devices are on the same network |
| Keeps disconnecting | Unstable network connection | Use a wired Ethernet cable instead of Wi-Fi |
| Some commands fail | Feature not supported on your model | Check your ATEM's firmware version; some features need newer firmware |
| Audio sources not showing | Audio routing needs adjusting | Check audio routing in ATEM Software Control |
Rollback / Fallback
Turn off advanced ATEM commands.
Keep basic switching only (cut/auto transitions).
Use ATEM Software Control or the hardware panel for advanced features.